Reliant FVIR GAS WATER HEATER Instructions d'exploitation télécharger pdf (Page 15)

Installing the water heater

❑ DO check inlet gas pressure to ensure that

it is within the range specified on the rating

plate.

❑ DO provide adequate air for combustion

and ventilation as discussed in the Use and

Care Manual and the National Fuel Gas

Code.

❑ DO maintain proper clearances to

combustibles as specified on the rating plate.

❑ DO ensure that the venting system

complies with the guidelines found in the

Use and Care Manual and National Fuel Gas

Code.

❑ DO contact a qualified service technician

if the pilot or main burner will not stay lit.

The burner chamber is designed to be sealed

utilizing a gasket and tamper resistant screws.

DON’T

❑ DON’T block or restrict Combustion

Air Inlet Openings located around the lower

portion of the water heater jacket.

❑ DON’T remove the Burner Access Door

unless absolutely necessary. This should only

be done by a qualified service technician.

A new burner access door gasket must be

installed on any burner access door that has

been removed.

❑ DON’T install this water heater where

standing water may occur. The base of the

water heater is meant to be mounted on a dry

surface.

❑ DON’T operate the water heater if the

sight glass or burner access door grommet is

damaged or broken.

During Installation of this water heater

Burner

Access Door

Grommet

Sight Glass

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Reliant FVIR GAS WATER HEATER Instructions d'exploitation Page 15