Reliant FVIR GAS WATER HEATER Guide d'utilisation et d'entretien Page 21

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 20
21
Gas Control/Temperature Knob
Status Light
ON
OFF
STATUS
120°F
Position
A
B
C
VE
R
Y
HOT
HOT
LOW
VA C
A
B
C
VERY
HOT
HOT
LOW
VA C
160°F (Approx.)
110°F (Approx.)
70°F (Approx.)
Water
Temperature
°F
Time for 1st
Degree Burn
(Less Severe Burns)
Time for Permanent Burns
2nd & 3rd Degree
(Most Severe Burns)
110 (normal shower temp.)
116 (pain threshold)
116 35 minutes 45 minutes
122 1 minute 5 minutes
131 5 seconds 25 seconds
140 2 seconds 5 seconds
149 1 second 2 seconds
154 instantaneous 1 second
(U.S. Government Memorandum, C.P.S.C., Peter L. Armstrong, Sept. 15,1978)
NOTE: During low demand periods when hot water is not
being used, a lower thermostat setting will reduce energy
losses and may satisfy your normal hot water needs. If hot
water use is expected to be more than normal, a higher
thermostat setting may be required to meet the increased
demand. When leaving your home for extended periods
(vacations, etc.) turn the temperature dial to its lowest
setting. This will maintain the water at low temperatures
with minimum energy losses and prevent the tank from
freezing during cold weather.
Water Temperature Adjustment
The water temperature setting can be adjusted from 70°F to
160°F. Turn the Gas Control/Temperature Knob to the desired
setting/temperature.
NOTE: The temperatures indicated are approximates. The actual
temperature of the heated water may vary.
Operating Modes and Settings
Standard Mode - The controller adjusts the water
heater to maintain the temperature set by the user.
• Vacation Setting - The Vacation Setting (VAC) sets
the controller at approximately 70°F. This setting is
recommended when the water heater is not in use for a
long period of time. This effectively turns the controller
temperature setting down to a temperature that
prevents the water in the water heater from freezing
while still conserving energy.
Status Light Code
Table 5
LED FLASH SEQUENCE CONTROL STATUS
Short flash once every four second IDLE (No call for heat, no fault conditions)
“Heartbeat”, alternates bright/dim Call for Heat (No fault conditions)
One Flash, three second pause Low Flame Signal (control continues to operate)
Two Flash, three second pause End Switch Failed Closed
Three Flash, three second pause End Switch Failed Open or TCO Limit Lockout
Four Flash, three second pause ECO Limit Lockout (Overheat Failure)
Five Flash, three second pause Flame Out of Sequence
Six-One Flash, three second pause Soft Lockout* - Retry Limit - Failed TFI (Trial for Ignition)
Six-Two Flash, three second pause Soft Lockout* - Recycle Limit - Flame Lost - END Switch Fails
Six-Three Flash, three second pause Soft Lockout* - Recycle Limit - Flame Lost
Six-Four Flash, three second pause Soft Lockout* - Flame out of Sequence Sensed
Seven Flash, three second pause Flammable Vapor Sensor (FVS) Lockout
Eight-One Flash, three second pause Flammable Vapor Sensor (FVS) Fault Detected
Eight-Two Flash, three second pause Temperature Sensor Fault Detected
Eight-Three Flash, three second pause Electronic Fault Detected
Eight-Four Flash, three second pause Gas Control Valve/Thermostat Fault Detected
* Soft Lockout - 20 minute wait before returning to normal mode.
FIGURE 22.
Vue de la page 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Commentaires sur ces manuels

Pas de commentaire